Internal throttle

This is the internal throttle fitted. It’s for 1 inch bars, but there was plenty of meat on the section that fits into the cut down handlebar. Plus these BMX bars aren’t very thick walled, Chro-mo, don’t you know! I made a slug to stuff in the end because the twist sleeve bit is ridiculously short. I extended the bars on the other side to match the new width using part of the bit I cut off from the throttle side.

My plan is to have just the brake hose and clutch cable visible, so it looks like the brakes on a BMX, if the BMX has two brakes, and massive levers.

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s